Connection To The Wi-Fi Network - Stocker Geyser Pro Benutzerhandbuch

Art. 415 – Geyser Pro

4.6 Connection to the Wi-Fi network

The Geyser Pro has a built-in Wi-Fi module for remote management via a web interface. The
connection to the Wi-Fi network must be made during initial commissioning or later if the network
is changed.
Step 1 - Activating Wi-Fi Mode
1. Press and hold the Wake-Up side button until LED 1 turns solid white.
2. LEDs 2-3-4-3-2 will start flashing blue in sequence: the device is now in Wi-Fi search
mode (access point active).
Step 2 - Connection to the Geyser
1. On your smartphone, tablet or PC, access the list of available Wi-Fi networks.
2. Select the network generated by the Geyser ("Stocker ? Geyser").
3. Once connected, the browser will automatically open and propose the configuration.
If it does not open automatically, click on the 'settings' of the network generated by
Geyser.
Step 3 - Home Network Configuration
1. On the configuration page:
a. Select your home Wi-Fi network from the list of available networks.
b. Enter the network password and confirm.
2. The Geyser will attempt to connect to the selected network. In case of success:
a. LED 1 turns steady blue.
b. The signal level will be displayed via the following LEDs:
i. 1 Blue LED: weak signal
ii. 2 blue LEDs: good signal
iii. 3 blue LEDs: optimum signal
iv. 4 blue LEDs: perfect signal
Step 4 - Accessing the Web Interface
1. Scan the QR code inside the Geyser, attached to the structure
2. Continue with the registration of a new user and follow the steps indicated in the
application.
Additional information:
In the event of a failed connection, LED 2 will flash red.

If the Wi-Fi signal is unstable, consider using a Wi-Fi repeater in the vicinity of the

Geyser.
manual
Contact: info@stockergarden.com
Newsletterwww.stockergarden.com/eventi-servizio/newsletter
REV 1.0
21