Technical Data - AEG BP7614000 Benutzerinformation

Problem
The display shows C2
The display shows C3
The display shows F102
The display shows an error
code.
Steam and condensation col-
lect on the food and in the ap-
pliance.
If you cannot find a solution to the problem yourself, contact your dealer or the service
centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the
front frame of the oven cavity.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

TECHNICAL DATA

Voltage
Frequency
Possible cause
You want to start the Pyrolytic
cleaning, Keep warm or Defrost
function but you did not re-
move core temperature sensor
plug from the socket.
You want to start Pyrolytic
cleaning but you did not close
the oven door correctly.
The door lock is defect
There is an electronic fault
You left the dish in the appli-
ance for too long.
230 V
50 Hz
Technical data
Solution
Remove the core temperature
sensor plug from the socket.
Close the door correctly.
• Close the door correctly
• Deactivate the appliance
with the house fuse or the
safety switch in the fuse box
and activate it again
• If the display shows F102
again, refer to the Customer
Care Department
• Deactivate the appliance
with the house fuse or the
safety switch in the fuse box
and activate it again
• If the display shows the er-
ror code again, refer to the
Customer Care Department
Do not let the dishes stay in
the appliance for longer than
15-20 minutes after the cook-
ing is completed.
.........................................
.........................................
.........................................
27