Herunterladen Diese Seite drucken

Danfoss TPOne-S Installationsanleitung Seite 4

Vorschau ausblenden Andere Handbücher für TPOne-S:

Werbung

Installation Instructions
Speci cations
Operating Voltage
Setting temperature range
Operating temperature range
Switch rating
Switch type
Transmission frequency
WiFi Speci cation
Transmission range
(in normal buildings)
Transmission power
IP rating
On/o control
Chrono-proportional control
Operating mode
Construction
Pollution degree rating
Rated impulse voltage
Dimensions (mm)
Battery backup time
Software Classi cation
Important note RF products: Ensure that there are no large metal objects, such as
boiler cases or other large appliances, in line of sight between the transmitter and
receiver as these will prevent communication between thermostat and receiver.
ErP Class
The products represented within this document are classi ed according
to, and allow completion of, the Energy Related Product (ErP) Directive
System Package che and the ErP system data label. ErP Labelling
obligation is applicable from 26th September 2015.
ERP Class Product Function and ErP Description
Modulating Room Thermostat, for use with
V
modulating heaters
An electronic room thermostat that varies the
ErP
heater dependent upon measured room
5
Product
Class
temperature deviation from room thermostat
set point. Control is achieved by modulating
the output of the heater.
4
ow temperature of the water leaving the
TPOne-S
230V AC, 50 Hz
5-35°C
0-45°C
-
-
868.42 MHz
802.11b/g (2.4GHz)
up to 30m
Max 1 mW
IP20
Heating
EN 60730-2-7
Degree 2
H66 x W155 x D30
24 Hours
DBR
-
3A (1) at 230Vac
SPST Type 1A
-
IP40
Yes
Yes
-
EN 60730-1
4 kV
H84 x W84 x D30
A
Additional
e ciency
gain
3%
TPOne-S

Werbung

loading