Connecting Your Dtb-D700F - Samsung DTB-D700F Bedienungsanleitung

CONNECTING YOUR DTB-D700F

1. LOCATION OF THE RECEIVER
Your DTB-D700F should be placed under proper ventilation.
Don't put in completely enclosed cabinet that will restrict the flow of air, resulting in
overheating.
The location should be safeguarded from direct sunlight, excess moisture, rough
handling or household pets.
Avoid stacking other electronic components on the top of the receiver.
The location should be safely accessible by the cable from your antenna system.
2. CONNECTING THE RECEIVER WITH AERIALS
You can connect the receiver to the following type of aerials:
Use a standard outdoor roof aerial intended for receiving channels between
VHF and UHF.
Because many older roof-mounted aerials may only receive a limited number of
channels, it is difficult or impossible to receive digital channels transmitted on higher
frequencies. If so, you may replace the roof aerial.
Some outdoor aerials are directed towards an analogue transmitter.
The aerial must be directed towards a digital TV transmitter.
It is not desirable to use indoor or window mounted aerials, as it will be difficult or
impossible to receive digital channels.
3. CONNECTING THE RECEIVER TO TV
To connect the receiver with your television, you can use Scart Cable or RCA cable.
In the case of connecting your TV through SCART cable, connect the SCART connector
marked TV to the respective SCART port on the TV.
4. CONNECTING YOUR VCR
To connect a VCR, the receiver has been provided with SCART at the rear marked
"AV2(EXT)". Using a SCART connector, the VCR can be connected to the receiver.
5. CONNECTING YOUR ANALOG RECEIVER
To facilitate the user using analog receiver to view analog channels,
DTB-D700F has been provided with a loop through terminal marked as "LOOP".
Connect the coaxial cable from this terminal to the IF input terminal of your analog
receiver. Now by keeping the DTB-D700F in standby, you will be able to tune and view
analog channels from your analog receiver.
6. CONNECTING EXTERNAL AUDIO / HI-FI SYSTEM
To connect any external Audio Hi-Fi system, the receiver has been provided with two
RCA connectors at the back of the receiver, marked with AUDIO L and R respectively to
connect the left and right Audio.
7. CONNECTING DIGITAL AUDIO SYSTEM
Connect a fiber optic cable between DIGITAL AUDIO OUT( OPTICAL ) on the receiver
and OPTICAL on the Digital Audio System.
GB-10
D T T R E C E I V E R /
CONNECTING YOUR DTB-D700F
Connecting Figure
N N o o t t e e : In some region, the digital terrestrial signal may be weak.
So you'd better use the antenna in which the booster was built, for watching
the weak signal channels.
D V D P L A Y E R
GB-11