Setting Up The Parental Control; Troubleshooting; Disposal - Samsung DTB-D700F Bedienungsanleitung

SETUP FUNCTIONS (DVD)

5.5 Setting Up the Parental Control

The Parental Control function works in conjunction with DVDs
that have been assigned a rating - which helps you control the
types of DVDs that your family watches. There are up to 8
rating levels on a disc.
With the unit in Stop mode, press the DISPLAY key.
Select Parental Control using the / keys, then press
the OK key.
• Use the OK key to select On, if you want to use a
password.
• The Enter current password screen appears.
About the Rating Level :
The Rating Level will work only when use Password is set to
On. To unlock the player, use the OK key to select Off.
• Use the / keys to move Parental Level, then press
the OK key.
• Select Rating Level using the / keys, then press
the OK key.
- Kids : Select this to play only DVDs for children.
- 2 to 7 : Select this to play DVDs for general audiences and
children. Adult DVDs cannot be played.
- Adult : Select this to play only DVDs for adult.
About the Change Password :
• Use the / keys to select the Change Password.
• Press the OK key.
The Change Password screen appears.
• Enter your new password.
• Re-enter new password again.
N N o o t t e e : If you forget the password, contact your dealer or
service provider.
Once you change password, please do not forget and
keep well.
GB-44
D T T R E C E I V E R /

TROUBLESHOOTING

In some region, the digital terrestrial signal may be weak.
So you'd better use the antenna in which the booster was built,
for watching the weak signal channels.
You can download and upgrade the system software of the receiver through
a specific channel through a specific channel designated by the broadcaster.
The Distributor will provide you with more information about that.
Problem Possible cause
No display LED on Power cord
the front panel; not plugged in correctly
No power supply
No pictures on the screen Receiver in Standby mode;
Scart not connected tightly
to video output of television;
incorrect channel or video
output selected on television
No sound Audio cord connected
incorrectly;
Loudness level = 0;
Muting active
Remote Control does not incorrect operation;
operate directly
Batteries dead or inserted
incorrectly
Poor picture quality Signal strength too low
On-Screen Error Message Antenna cable not connected
"Searching for signal" or not tight;
incorrect position of the
antenna;
On-Screen Error Message Receiver not yet set
"Channel data
does not exist."

DISPOSAL

The device, packaging material (e.g. Styrofoam) and the batteries must never
be disposed of with household refuse.
Please obtain appropriate information about the regulations in your community,
and dispose of all refuse in accordance with regulations at the separate
locations provided.
D V D P L A Y E R
Solution of the problem
Power cord plug in correctly
Back switch in correctly
Set receiver to "On";
Check connection and correct;
Check channel and video output and
correct (TV instruction manual)
Check connection and correct;
Increase loudness on television set;
Press the MUTE key
Point remote control
towards the Receiver.
Replace batteries or insert correctly
Check the signal strength in
the "Auto Scanning" menu, correct
alignment of your antenna
Check connection and correct;
Check position and correct,
Check the signal strength in
the "Auto Scanning" menu
Scanning of in "Auto scanning"
or "Manual scanning" menu
GB-45