Werbung
Verfügbare Sprachen
Verfügbare Sprachen
to first pump up a large-volume item with air,
in order to then generate the required pressure
with the product.
Testing air pressure
Note: The pressure gauge of the product is not
trade-approved.
Connect the inflatable item whose pressure
you want to check to the valve connection
of the product´s connection hose
so, proceed as described in the section
"Setting up the product".
Switch the product on by pressing the On/Off
button
for approx. 3 seconds.
4
Select the appropriate mode by pressing the
"Mode" button
3
between "Car mode", "Motorbike mode",
"Bicycle mode" or "Leisure mode".
Select the required unit of pressure next by
pressing the "Mode" button
3 seconds and then pressing it once again.
You can choose between the units pounds per
square inch ("psi"), bar ("bar"), kilopascal
("kPa") and kilogrammes per square centimetre
("kg/cm
").
2
The display
now shows the pressure of the
1
connected inflatable item in the preset unit.
Disconnect the inflatable item from the valve
connection
of the product´s connection
13
hose
.
9
Note: When disconnecting the valve connec-
tion
of the product´s connection hose
13
air can escape from the valve of the inflatable
item. Ensure that you remove the valve con-
nection
as quickly as possible.
13
Using the light mode
To switch on the LED light
button
twice briefly.
6
To switch the LED light
mode, press the LED button
To switch the LED light
button
once more.
6
CAUTION! Do not look directly at the LED
light
. There is a risk of injury!
11
ATTENTION! The light mode can not be
used while the product is being charged.
. To do
9
repeatedly. You can choose
for approx.
3
, press the LED
11
to SOS and flash
11
once more.
6
off, press the LED
11
Troubleshooting
= Fault
= Cause
= Solution
= Product does not react when the
On/Off button
= The undervoltage protection is activated for
13
the product.
= Charge the device as described in the
section "Charging the product".
Cleaning and maintenance
Before cleaning, switch the product off by
pressing the On/Off button
3 seconds. Afterwards, disconnect the USB
charging cable
Do not immerse the electrical parts of the pro-
duct in water or other liquids. Never hold the
product under running water.
After cleaning, wait until all parts become
completely dry before using the product
again.
Note: The built-in battery can discharge even if
the product is not in use. If you do not plan to use
the product for a longer period of time, fully charge
the built-in battery before storage to prolong the
battery's operating life.
Note: Regularly charge the built-in battery during
,
9
non-use (we recommend an interval of 3 months)
to preserve its characteristics.
Storage
Keep the product in a dry location and out of
the reach of children.
To avoid damage, ensure that the connection
hose
does not get kinked.
9
Store the adapters (
charging cable
ment located under the cover cap
is pressed.
4
for approx.
4
from the product.
18
,
,
) and the USB
15
16
17
in the accessory compart-
18
.
7
GB/IE
23
Werbung
