Cleaning And Maintenance; Cleaning; Blade Maintenance; Replacing The Blade - Powerplus Powdpgbox24 Bersetzung Der Originalbetriebsanleitung

Warning: remove the battery pack from the trimmers before handling
setting.
Warning: Always wear safety glasses. Never lean over the cutting head.
Stones or debris can bounce or be thrown into eyes and face and blind you
or serious injury. To use the machine, note the following points: Put on
heavy clothing and eye protection. Hold the front handle with one hand and
the auxiliary handle with the other hand. Store unit below the waist level.
Have the unit from right to the left so that residues are always projected on
the side opposite you. While avoiding bending over, keep the section
parallel to the ground wire (or perpendicular to trim edges) and prepared
the material to be cut (but not touching).
Warning: Before starting work, make sure that the cutting blades are long
enough. Do not start work before the engine running at full speed.

15 CLEANING AND MAINTENANCE

15.1

Cleaning

▪
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean cloth or blow it with compressed air at low
pressure.
▪
We recommend that you clean the device immediately each time you have finished using
it.
▪
Clean the equipment regularly with a moist cloth and some soft soap.
▪
Do not use cleaning agents or solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the device.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
15.2

Blade maintenance

▪
Regularly remove grass and dirt from the blade.
▪
At the beginning of the gardening season, carefully examine the condition of the blade.
▪
If the blade is very blunt, sharpen or replace the blade.
▪
If the blade is damaged or worn, fit a new blade.
▪
If the blade is slipping, put the screwdriver into the location hole, tighten the blade by
wrench.
Warning! Observe the following precautions:
▪
Be careful not to cut yourself. Use heavy-duty gloves or a cloth to grip the blade.
▪
Only use the specified replacement blade.
▪
Do not remove the impeller for any reason.
15.3

Replacing the blade

For safety reasons, we recommend having the blade replaced by an
authorized professional.
Important: Wear work gloves!
Copyright © 2024 VARO
POWDPGBOX24
P a g e | 15
EN
www.varo.com