Charging Indication (Fig 1); Battery Capacity Indicator (Fig. 2); Assembly Lawn Mower; Handle Assembly - Powerplus Powdpgbox24 Bersetzung Der Originalbetriebsanleitung

10.1.1

Charging indication (Fig 1)

Connect the charger to the power outlet socket
▪
Solid green: ready to charge
▪
Flickering red: charging
▪
Solid green: charged
▪
Solid green and red: battery or charger damaged
Note:If the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
1. Frequently monitor the charger and battery pack while connected
2. Unplug the charger and disconnect it from the battery pack when finished.
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
NOTE: Remove battery pack from charger stand which use your thumb or
fingers, press the battery's release button in and pull the battery pack off at
the same time.
10.2

Battery capacity indicator (Fig. 2)

There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button. Before using the machine, please press switch trigger to
check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED's are litt: Battery fully charged
2 LED's are litt: Battery 60% charged
1 LED is litt: Battery almost discharged

11 ASSEMBLY LAWN MOWER

11.1

Handle assembly

11.1.1

Mounting the lower handle. (Fig. 3)

▪
Remove the locking knob(5) and washer on both sides, located above the rear wheels
▪
Slide the lower handle (8) over the mounting bolts located above the rear wheels.
▪
Slide the washers over the bolts.
▪
Fasten the handle with the locking knobs (5).
11.1.2 Assembly of the upper handle (Fig. 4a & 4b):
▪
Insert one long mounting bolt through the opening at one side of the lower handle(8), with
the end facing outwards.
▪
Place the upper handle(10) over the end of the bolt, install washer and upper handle
knob(9).
▪
At the opposite side, lign up the holes of the upper(10) and lower(8) handle and mount the
other long bolt.
▪
Install washer and upper handle knob(9). Tighten both knobs.
Copyright © 2024 VARO
POWDPGBOX24
P a g e | 11
EN
www.varo.com