Makita DCE090 Betriebsanleitung Seite 14

Changing the V-belt
1.
2. Loosen the hex socket bolts using the hex wrench
and then remove the cover .
Fig.22: 1. Hex socket bolt 2. Cover
3.
Fig.23: 1. V-belt 2.
NOTICE:
Never turn the box wrench counter-
clockwise. Doing so loosen the bolt on the pulley
(large) and result in poor performance.
TROUBLESHOOTING
ment parts for repairs.
State of abnormality
Motor does not run.
Motor stops running after a little use.
The wheel rotation does not acceler-
tool without load for 20 seconds.
Poor cutting performance
Water leaks from the inlet.
3. Box wrench
Probable cause (malfunction)
Overheating.
The V-belt is slipping.
The V-belt is slipping.
guard and the wheel.
Improper attachment of the wheel.
Electric or electronic malfunction.
It is time to replace the wheel.
Water is leaking from the O-ring part.
14 ENGLISH
4.
Fig.24: 1.
Make sure that all the guides on the internal circle of the
a rail which does not support the guide, the V-belt is not
Fig.25: 1.
5. Place the cover onto the tool and tighten the hex
socket bolts using the hex wrench.
Fig.26: 1. Tube 2. Cover 3. Hex socket bolt
NOTICE:
Make sure that the tube for water feed
attaching the cover.
Remedy
Stop using of tool to allow it to cool down.
manual.
Replace the V-belt with new one.
Replace the V-belt with new one.
Install the wheel as instructed in this manual.
Replace the wheel with new one.
2. 3. Box wrench
2. Guide on the V-belt
-