Eureka PROMETHEUS Gebrauchsanweisung Seite 44

• Push it forward until the activation button is pressed (5).
Dispensing ends when the time set in programming has elapsed. Once
dispensing has been completed, the grinding time returns to the set value
and the coffee grinder is ready for a new grinding operation. If the continuous
program (M), has been selected, delivery lasts for as long as the activation
button is pressed (5) and ends when it is released.
ATTENTION
Automatic dispensing can be stopped before the grinding time has
elapsed. Dispensing can be stopped by pressing the activation button (5)
with the filter holder:
• Press the grinding start button (5) again to resume dispensing for the
remaining time.
• Press any program button to stop dispensing.
8.2 AUTOMATIC FILTER HOLDER RECOGNITION
MODE
In this mode, the appliance recognizes the filter holder being used and
automatically selects the correct program.
Programs 1, 2 and 3 will be selected for 1-dose, 2-dose and "naked" filter
doses, respectively.
• Make sure you have correctly adjusted the filter holder recognition sensor (7)
• Press the automatic filter holder recognition button (G) to enter the
recognition mode.
• Place the filter holder cup on the fork (6), making sure that it rests correctly.
• Push it forward until the activation button is pressed (5).
The appliance will start grinding by automatically selecting the program.
Once dispensing has been completed, the grinding time returns to the set value
and the coffee grinder is ready for a new grinding operation.
ATTENTION
In this mode, it is not possible to set different grain sizes.
If the grain size is changed, such change will be applied to all programs.
ATTENTION
Remember to remove the filter holder from the fork after each dispensing
operation. Do not leave the filter holder on the fork for more than 10
seconds. If grinding does not start when the activation button (5) is
pressed, remove the filter holder from the fork, wait 5 seconds and try
22