Manual Mode - Eureka Prometheus Gebrauchsanweisung

hopper (Fig. 6) and then activate the motor by pressing the button
. To delete the changes, press
7.4 DISABLING PROGRAM ADJUSTMENT
Press the buttons (H)
size and grinding time, respectively. When pressed, the symbols
will be displayed on the buttons. Press (H) and (I) again to enable the
adjustments.
7.5 ADJUSTING THE DISPENSING NOZZLE
The angle of the dispensing nozzle (4) must be adjusted according to the
filter holder and the type of coffee used: this allows the coffee to flow correctly
(Fig.10).
7.6 ADJUSTING THE FILTER HOLDER
The fork is suitable for any type of filter holder available on the market.
• Use a Phillips screwdriver to loosen the fork fixing screw (6) and the screw of
the automatic filter holder recognition sensor (7).
• Next, raise or lower the fork to adjust it according to the size of the filter
holder.
• Once the correct position has been found, hold the filter holder cup perfectly
horizontal (Fig.11), and tighten the fork fixing screw (6)(Fig.9).
7.7 ADJUSTING THE AUTOMATIC FILTER HOLDER
RECOGNITION SENSOR
To ensure correct operation, the sensor must be positioned at the correct
distance (7) with respect to the spouts of the filter holder.
• Use a Phillips screwdriver to loosen the fixing screw located under the
sensor plate (Fig.11).
• Next, place the sensor (7) at a distance of about 2mm from the filter holder;
for greater accuracy, use the dedicated spacer.
• Once the correct position has been found, tighten the fixing screw.
8 OPERATION
8.1

MANUAL MODE

• Select the program using the corresponding buttons(J,K,L,M).
• Place the filter holder cup on the fork (6), making sure that it is precisely
under the dispensing nozzle (4).
and (I) to disable the adjustment of the grain
.
and
21