Preliminary Operations; Switching On The Appliance - Eureka Prometheus Gebrauchsanweisung

7 ADJUSTMENTS
7.1

PRELIMINARY OPERATIONS

• Before starting to work, the appliance must be adjusted according to the type
of coffee blend and the desired degree of grinding.
• Carry out the electrical connection and then open the lid (1) and turn the lever
(2) to "CLOSE" to close the coffee bean container.
• Fill the container with coffee beans, turn the lever (2)to "OPEN" allowing the
coffee beans (Fig.5-6) to move through.
ATTENTION
For correct ground coffee stability, the container (1) must be at least 50%
full.
7.2

SWITCHING ON THE APPLIANCE

Set the switch (9) to ON (power button to "I").
The first time the appliance is switched on, the factory settings are used
by default. At each subsequent start, the settings in use prior to shut-down
will remain set.
ATTENTION
We recommend calibrating the appliance before using it for the first time
(chap. 7.5).
7.3 PROGRAM ADJUSTMENTS
This model features three different programs plus the continuous mode. Each
program can be adjusted independently of the others.
Press the button (J,K,L,M) that corresponds to the program to be set; next, use
the the adjustment button (F) to change the time
selected icon will turn green).
To adjust the value, use the knob (8) or use the slider (O) on the display.
Rotate counter-clockwise to make the powder finer or clockwise to increase the
grain(Fig.7-8).
ATTENTION
If the grain size is reduced by more than 10 points, close the
20
or the grain size (the