GYS NOMAD POWER 701 FC Betriebsanleitung Seite 10

User manual
Acid projection hazard!
• Wear safety goggles and protective gloves
• If your eyes or skin come into contact with battery acid, rinse
the affected part of the body with plenty of water and seek
immediate medical assistance.
Connection / disconnection:
• Disconnect the power supply before connecting/disconnecting
the device to/from the battery.
• The terminal of the battery that is not connected to the car
frame must be connected first. The other connection must be
made on the car frame, far from the battery and the fuel line.
• After the start-up operation, disconnect the booster. First
remove the chassis connection and then the battery
connection, in the order shown.
Class II device (NOMAD POWER charger)
Class III device (NOMAD POWER).
Entretien :
• The power supply cable cannot be replaced. If the cable is
damaged,the device should not be used (NOMAD POWER
charger).
• Service should be performed by a qualified person
• Warning! Always remove the power plug from the wall socket
before carrying out any work on the device.
• Under no circumstances should solvents or other aggressive
cleaning agents be used.
• Clean the device's surfaces with a soft, dry cloth.
Regulations
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
• Equipment in compliance with British requirements. The
British Declaration of Conformity is available on our website
(see home page).
• Equipment in conformity with Moroccan standards.
• The declaration C‫( م‬CMIM) of conformity is available on our
website (see cover page).
10
Translation of the original
instructions
NOMAD POWER 701 / 801 / 901 FC