GYS NOMAD POWER 701 FC Betriebsanleitung Seite 13

User manual
USING AS POWER SUPPLY
Charging an electronic device
1. Connect the charging cable supplied to the rapid charging output
charged to the appropriate output of the booster
2. Connect the other end of the charging cable to the device to be charged.
3. Touch the switch button
phone/tablet etc.
For power supply to vehicle products or electronics
1. Plug the optional switch cable to 15 V /10 A output port
2. Connect the optional switch cable and vehicle product or electronics
3. Press the switch button
USING AS LED FLASH LIGHT
Press the button 2 3 seconds to start the LED flash light
There are 4 modes of LED light appear in order (normal. strobe. SOS. off) if you press slightly.
PROTECTIONS
This device is protected against overload, overheating, overintensity, deep discharge, short circuit and polarity reversal.
TROUBLESHOOTING
Finding
No response when pressing the
switch button
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
Translation of the original
instructions
5
, it can recognise eletronic products's suitable parameters, start to charge for mobile
2
to power supply
2
Low voltage protection of NOMAD
POWER is started.
or the charging cable of the device to be
7
.
6 7
3
.
4
Cause
Plug the adaptor into the Quick
Charge input port to activate
NOMAD POWER 701 / 801 / 901 FC
Remedies
13