Weller WXR 3 Originalbetriebsanleitung Seite 19

For your safety
Starting up the device
Caution!
Please adhere to the operating instructions of
the connected devices.
Put the tool into operation as described in the
МСaptОr „PХaМТnР Тnto opОratТon"έ
Check to see if the mains voltage mat-
ches the ratings on the nameplate.
Soldering and desoldering
ωarrв out soХНОrТnР worФ as НТrОМtОН Тn tСО opОra-
tТnР ТnstruМtТons oП вour МonnОМtОН soХНОrТnР tooХέ
Handling the soldering tips
„
Coat the selective and tinnable soldering tip with
soХНОr wСОn СОatТnР Тt up Пor tСО irst tТmОέ TСТs
removes oxide coatings which have formed
during storage and impurities from the soldering
tip.
„
Make sure that the soldering tip is well coated
with solder during breaks between soldering work
and prior to storage of the device.
ϊo not usО aРРrОssТvО luxТnР aРОntsέ
„
χХwaвs maФО surО tСat tСО soХНОrТnР tТps arО
„
ittОН propОrХвέ
„
Select as low a working temperature as possible.
„
Select the largest possible soldering tip shape for
the application.
RuХО oП tСumbμ tСО soХНОrТnР tТp sСouХН bО rouРСХв
as large as the soldering pad.
„
Coat the soldering tip well with solder to ensure
Overload cut-out
To avoid overloading the station, power output is
automatТМaХХв rОНuМОН Тn tСО ОvОnt oП an ovОrХoaНέ
www.valuetronics.com
Make sure the machine is switched off before
plugging in.
After switching on the device, the microprocessor
carries out a self- test and reads out the values of
the parameters stored in the tool.
TСО sОtάpoТnt tОmpОraturО anН ixОН tОmpОraturОs
are stored in the tool. The actual temperature
vaХuО ТnМrОasОs to tСО sОtάpoТnt tОmpОraturО (ο
soХНОrТnР tooХ Тs СОatОН up)έ
tСat tСОrО Тs ОПiМТОnt СОat transПОr bОtwООn tСО
soldering tip and the soldering area.
„
Prior to extended breaks between soldering work,
swТtМС oПП tСО soХНОrТnР sвstОm or usО tСО WОХХОr
function to reduce the temperature when the
soldering equipment is not in use.
ωoat tСО tТp wТtС soХНОr prТor to storaРО ТП вou Нo
„
not intend to use the soldering iron for an
extended period of time.
χppХв soХНОr НТrОМtХв to tСО soХНОrТnР arОa, not to
„
the soldering tip.
„
Change the soldering tips using the designated
tool.
ϊo not appХв mОМСanТМaХ ПorМО to tСО soХНОrТnР
„
tip.
Notice
The control units have been adapted to hold a
medium-sized soldering tip. Discrepancies may
occur if the tip is changed or a different shaped
tip is used.
37