Cleanmaxx T96A Bedienungsanleitung Seite 14

EN
USE
Please Note!
■
Ensure that there are no larger, sharp
objects on the surface which is to be
cleaned.
■
Do not use the nozzles (11, 14) to suck
up dust or dirt! If dirt were to get inside
the motor unit, this could damage the
motor.
■
For the suction function, the collecting
container with one of the filter needs
to be attached to the device. The filter
must not be damaged! If dirt were to
get inside the motor unit, this could
damage the motor.
■
Empty and clean the collecting container
after each use. Also clean the filter
regularly in order to prevent overloading
of the motor.
■
Switch the device off after each surface
has been cleaned as this will considerably
increase the operating time on each
battery charge.
1. Attach the accessory you want (see the
"Attaching / Detaching Accessories"
chapter).
L
To get more effective performance
from the blower, detach the collect-
ing container from the motor unit.
2. For the vacuum function: insert the
nozzle into the object to be emptied
before switching on.
3. Switch on the device:
○ To switch on at low level, press the
button (10) for approx. 3 seconds.
○ Pressing the button again selects the
high level.
4. For the suction / blower function: guide
the nozzle over the area to be cleaned.
14
14539_14923_14924_Inlay_DE-EN_A5_V1.indb 14 14539_14923_14924_Inlay_DE-EN_A5_V1.indb 14
5. To switch off the device, press the
button again.
L
To ensure optimum suction perfor-
mance of the device, empty and
if necessary clean the collecting
container after every use (see the
"Cleaning and Storage" chapter).
CLEANING AND STORAGE
Please Note!
■
Do not use any sharp or abrasive cleaning
agents for cleaning. They may damage
the surfaces.
L
The filters may lose some of their
colour over time. This is normal and
does not have any adverse effect on
function.
1. Detach the nozzle.
2. Twist the collecting container (2) anti-
clockwise and detach it from the motor
unit (5) (Picture B1).
3. Remove the filter (3 or 18) (Picture B2).
4. Empty the collecting container over an
open dustbin.
5. Tap out the used filter and clean it with
a soft brush if necessary. Both filters can
also be rinsed out with clear water, but
they must be completely dry before
being reinserted!
6. Wipe down the collecting container
if necessary using a soft dry cloth.
7. Remove hair and fluff from the used
accessory.
8. Store all parts in a cool, dry place which
is protected from direct sunlight and is
out of the reach of children and animals.
16.04.2024 15:03:21 16.04.2024 15:03:21