ADE WS 1911 Kurzanleitung Seite 25

2. Insert 2 batteries of type LR3/R3 (AAA)/1.5 V as depicted
3. Slide the battery compartment cover back into place
Backup battery
1. Use a coin or similar to open the battery compartment
2. Remove the lid.
3. Push the batteries against the contact springs under
4. Put the battery compartment cover back on and turn it
Making the electrical connection
WS 1911 weather station
QSG WS 1911 Druckbuch.indb 25 QSG WS 1911 Druckbuch.indb 25
on the bottom of the battery compartment. Pay
attention to the correct polarity of the batteries (+/-).
on the outdoor sensor.
The base station can also be operated without
a storage battery. However, operation with the
storage battery alone is not possible.
on the back of the base station by turning the round
cover counter-clockwise as far as it will go.
the large, angular retaining tabs. The battery then
snaps into place under the side retaining tabs so that
the battery is firmly seated in its holder.
Pay attention to the correct polarity. The plus pole (+)
must point upwards.
clockwise until it stops.
NOTE on material damage
‚ Use only the supplied mains adaptor.
9
31.01.2025 13:43:49 31.01.2025 13:43:49