Tool Operation - Aerfast TS55-14V Betriebsanleitung

Tool Operation

(2)
Main Switch
Forward/Reverse Rod
(1)
11.
4. Move the strip forward until the
nd
2 empty slot is aligned with
the bit. This will allow for the
proper strip advancement once
the nosepiece is depressed.
1. Make sure the forward/reverse
rod direction (
2. Whenever possible, hold the
tool at a right angle to the
work surface.
3.
(1)Pull the main switch to start
the motor.
(2)Press the conduction, with
constant force, against the
work surface.
Do not remove the tool from
the work surface until the
clutch disengages and the
bit stops rotating, signaling a
fully driven screw.
)。