Aerfast TS55-14V Betriebsanleitung Seite 9

Operating Instructions
Installing or Removing Battery Pack
(See Fig.1 Fig.2 )
1. Always switch off the machine before insertion or
removal of the battery pack.
2. To remove the battery pack, push the button on the
battery pack and pull the tool unit from the battery
pack in the direction.
3. To insert the battery pack, align the tool unit slides
with the battery pack sliding groove and push the tool
unit into place.
The tool unit can be slide into battery pack in two
directions.
4. Do not force the battery pack in sliding it into tool unit.
If the battery pack does not slide in easily, it is not
being inserted correctly.
Charging the Battery Pack (See Fig.3)
1. Plug the fast charger into the power source.
2. Slide the battery pack into the charger as the arrow
direction shown on the charger.
3. Push the battery pack into place and make sure the
red light on the charger is "ON". The battery pack is
now starting the charging cycle.
4. After finish the charging cycle, the light will turn into
green. The battery pack is now ready for use.
5. Your new battery pack is not charged. You need to
charge it before use.
6. If you try to charge a battery pack from a just-operated
machine, sometimes the charging light will not come
on. If this occurs, let the battery pack cool for a while
then re-insert it and try to charge again.
7. When you charge a new battery pack or a battery
pack which has not been used for a long period, it
may not accept a full charge. This is a normal
condition and does not indicate a problem. You can
recharge the battery pack fully after discharging it
completely a couple of times.
8. While charging the second battery, allow the charger
to cool down for 15 minutes before start the second
charging process.
9. Unplug the charger from the power source after finish
the charge.
(Slide-In)
7.
Fig.1
1
2
Fig.2
Fig.3