Aerfast TS55-14V Betriebsanleitung Seite 15

Caution
When the battery pack is low or the drive requires too much torque, the
tool may stall at the bottom of the drive (before the clutch can disengage).
Continuous operation in this manner can cause over-heating and
permanent damage.
To Remove the Screws
(2)
(1)
Forward /Reverse Rod
Reverse knob
Reverse direction
Replaceable Non Slip Pad
(3)
Main Switch
Press
13.
1.
(1)Remove the strip, pull it through
from the top of the nosepiece.
Pull the collated screw upward
for removing.When the screw
is out of position or stuck, push
the reverse knob while pulling
the collated screw downward at
the same time.
Push the forward / reverse rod
to reverse side (
Depress nose piece while
inserting bit into screw.
(2)Maintain forward pressure on
tool.
(3)Pull the main switch to start
motor. Continue operation until
screw is completely
disengaged.
1. The non slip pad is self
replaceable if damaged or
dirty.
).