Kindermann USB-C HDBT3 Extender 4K60 Set Inbetriebnahme- Und Bedienungsanleitung Seite 22

7 Control
The USB-C HDBT3 Extender 4K60 Set supports control via API commands.
Connect a PC or control system to the service port of the transmitter.
The list of ASCII commands for the extender is shown below.
RS232 control protocol (virtual via USB-C)
Baud rate:
Data bit:
Stop bits:
Parity: none
System:
Description
List of all API commands
Get firmware version
prm = {...}// according to
actual firmware version
Get status
Reset to factory defaults
Reboot
Switch:
Description
Set TX Input:
prm = {0, 1, 2, 3}
0 = off,
1 = USB-C Eingang,
2 = AV Mute,
3 = Internal
Get TX input
22
115200 bps
8
1
None
Command
help<CR><LF>
GET FW VERSION
<CR><LF>
GET STATUS
<CR><LF>
SET RESET
<CR><LF>
SET REBOOT
<CR><LF>
Command
SET TX SOURCE
prm<CR><LF>
GET TX SOURCE<CR><LF>
Example of feedback
List of all commands
FW prm<CR><LF>
Status
Sure to RESET to default settings?
Type "Yes"
REBOOT<CR><LF>
Example of feedback
SET TX source to USB-C
USB-C
EN