K-FEE GRANDE Betriebsanleitung Seite 20

Programming cup
EN 1
capacity
Button Factory setting Setting range
[ml] [ml]
45 30 – 100
105 80 – 200
200 100 – 240
The appliance is ready for
65 65 – 130
operation. Place desired cup
under the spout.
4
Before programming, always
insert a new capsule into the
machine.
The newly programmed ll
quantity remains stored
(also if power is interrupted).
It is also possible to reset the ll
quantities of the cups to the fac-
tory settings. To do this, read the
frequently asked questions on page
Hold down the button for
52.
the desired beverage (e.g.
"lungo") for at least 3sec.
5
Open lever, capsule falls into
container.
38
2 3
Open lever and insert desired Close lever completely.
capsule.
3 sec. min.
The respective symbol will Press the same button again
start ashing on the display. as soon as the desired cup
Then release the button - the lling quantity has been
machine continues brewing. reached. The machine stops
the brewing process and
saves the new cup lling
quantity.