Herunterladen Diese Seite drucken

Zipro Neon Bedienungsanleitung Seite 13

Magnetischer crosstrainer
Vorschau ausblenden Andere Handbücher für Neon:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 16
EN
5. Install the computer
Connect the heart rate measurement cable (50) and the connecting
cable from the top of the handlebar column (18) to computer cables
(9). Fix the computer (9) to the handlebar column (2) using the bolts
(55).
6. Install the water bottle holder
Install the water bottle holder (66) on the handlebar column (2) using
the bolt (67) and the flat washer (68). Make sure the holder is secure
and insert the bottle.
13
ADJUSTMENTS
Resistance adjustment
In order to increase the resistance, turn the resistance knob clockwise.
In order to decrease the resistance, turn the resistance knob
counterclockwise.
Adjusting pedal straps
Fix the side of the rubber strap with three holes to the internal part of
the pedal. Fix the other end to one of the adjustment opening so that
the feet is fixed during training and easy to take out. Repeat for the
other pedal.
Levelling
Level the device by rotating the levelling pads on the rear base. The
pads are polygons, and each side has a different height. Find the right
one to stabilise the device.
COMPUTER MANUAL
COMPUTER (MODEL) MRMS02-BLU
Remove the safety film from the display before use.
AUTO ON/OFF
The computer is switched on when the flywheel moves or any button
is pressed. The computer is switched off after four minutes of
inactivity.
BUTTONS
MODE - selects the parameter.
SET - sets parameter values.
RESET - resets time, distance, and calories immediately.
FUNCTIONS (SPECIFICATION)
SCAN
Displays all measured training
parameters in a cycle.
TIME
Total exercise duration, from the
start to the end.
SPEED
Displays the current speed.
DISTANCE
Total distance from the start to
the end of the exercise.
CALORIES
Total calories burnt from the
start to the end of the exercise.
(The measurement is an
approximation for comparing
training sessions. Do not use for
medical purposes).
TOTAL
Total distance from battery
DISTANCE
installation.
(ODO)
PULSE
Displays the current heart rate.
ATTENTION! The heart rate is
measured for sports purposes
only (not for medical use).
SETTING COUNTDOWN VALUES
Press the MODE button repeatedly to select the parameter you
want to base your training on: time, distance, calories, or the
upper heart rate value. (The display should show only the
parameter, without the SCAN option.)
Press SET multiple times to set the value.
The countdown starts when you start pedalling. A down arrow
will be displayed on the screen.
When the countdown is over, or you reach the set heart rate
value, the device makes a sound.
PULSE RATE
ATTENTION! The heart rate is measured for sports purposes only (not
for medical use).
Press MODE until the display shows PULSE.
every 4 seconds
00:00-99:59 min
0,0-99,9 km/h
0,0-9999 km
0,0-9999 kcal
0-9999 km
40-240 BPM

Werbung

loading

Diese Anleitung auch für:

1592673