Installing The Appliance - AEG Electrolux ARCTIS G 7 88 53-6I Benutzerinformation

14
Installation

Installing the appliance

CAUTION!
Make sure that the mains cable can move freely.
Do the following steps:
1. If necessary cut the adhesive sealing
strip and then apply it to the appliance
as shown in figure.
2.
Install the appliance in the niche.
Push the appliance in the direction of
the arrow (1) until the upper gap cover
stops against the kitchen furniture.
Push the appliance in the direction of
the arrow (2) against the cupboard on
the opposite side of the hinge.
3.
Adjust the appliance in the niche.
The lower hinge cover (in the accessories
bag) makes sure that the distance be-
tween the appliance and the kitchen
furniture is correct.
Make sure that the distance between the
appliance and the cupboard front-edge
is 44 mm.
Make sure that the clearance between
the appliance and the cupboard is 4 mm.
Open the door. Put lower hinge cover in
position.
x
4mm
44mm
x
2
1