Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Extended »Connect« functions
App installation
Please locate the app »HT-Connect« in your respective app store (available for Android™ and
iOS, free of cost) and install it.
Make sure to activate your Wi-Fi and the Bluetooth function on your mobile phone or tablet.
The following instructions relate to a »Receiver T Connect« which is new, or one on which the
connection settings have been reset.
Configuration
Connection modes
The »Receiver T Connect« offers 2 connection modes:
- Connection between the phone and the receiver via Bluetooth
- Connection between the phone and the receiver via WiFi.
Both modes offer the display of lisa-signolux events on the smartphone. Both modes make it
possible, depending on the type of your phone's operating system, to have incoming calls and
messages indicated by the Lisa-Signolux system.
However, Bluetooth mode is very limited in transmission range and only recommended in
direct vicinity of the phone to the receiver.
Therefore we recommend to establish a connection via WiFi, which is almost unlimited in
range, as it directly connects the phone with the receiver via the domestic WiFi setup and
will also connect you automatically via the mobile data networks when you are not within your
living space. Please make sure that your WiFi setup is stable.
Connection indicator light
Successful connection to the Wi-Fi network is indicated by a weak white-green light within
the flash zone (1). Bluetooth connection is indicated by blue light. If the connection via the
cloudserver network is active, this will be indicated instead by yellow light.
Basic connection setup
Open the »HT-Connect« app on your phone or tablet. Tap on "Add device". Select "Lisa-
Signolux T Connect". Now authorize the requests your phone may display. After a short scan,
the receiver should be listed. The exact name of your device can be found in the battery
compartment. Tap on the the entry and connect with the »Receiver T Connect«. Now select
"Bluetooth" to connect.
®
Bluetooth
Mode
If you select "Bluetooth", your phone will connect to the »Receiver T Connect« via Bluetooth.
Authorize any permission requests which may appear on your phone. You will then see the
event icons overview page of the app. All functions are now accessible within the limited
transmission range of a Bluetooth connection. You can now access the various settings within
the app, which are briefly described in the following chapters.
English 23
Werbung
