Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.8. REGENERATION CYCLE
(only for "A" models)
The regeneration phase of the resins
EN
the dishwasher ON, FULL TANK and HOOD CLOSED.
2.8.a FILLING THE SALT TANK
First of all make sure that there is salt in the specific
container; otherwise, proceed as follows:
1. Unscrew the cap from the tank and introduce ONLY
COARSE COOKING SALT.
2. Fully screw the cap back on to make sure it is closed
properly.
2.8.b STARTING RESIN REGENERATION
Once the cycles set on the display are reached, A9 ap-
pears on the display, which means REGENERATION
REQUIRED.
Press the SCROLL key.
Select the C3 function from the display.
Press the START key.
The START key turns WHITE.
Lift up the HOOD.
Release the overflow and close the HOOD again.
The REGENERATION phase begins.
When the cycle has begun, the display on the right will
read C3.
If the tank is not drained, the alarm A10 will appear on
the display at the end of the cycle.
F1 appears if the hood is lifted up during the
regeneration
The regeneration cycle is interrupted and then resumes
when the hood is closed.
24
must start with
ATTENTION
At the end of the cycle, the machine switches off
automatically and the display reads OFF.
The machine is now ready for use.
ATTENTION
Pressing the START key for 5 sec. with the
REGENERATION cycle in progress, the cycle
is immediately interrupted, the dishwasher is-
switched off and OFF appears on the display.
If regeneration is interrupted it does not allow the indi-
cated REGENERATION REQUIRED to be eliminated
(alarm A9 on the display), which will reappear upon the
next switch-on.
IMPORTANT
Upon switch-on, after an interrupted regeneration,
wait for the tank to be restored until the START key
becomes STEADY GREEN or FLASHING GREEN.
Run a complete SELF-WASHING cycle
by performing the following
the SCROLL key.
Select the C1 function on the display.
To start the cycle, press the
START key.
At the end of the SELF-WASHING cycle the dishwasher
switches off and OFF will appear on the display.
The machine can be reused by re-inserting the overflow
in its original position and switching the dishwasher on.
Due to the interrupted regeneration, alarm A9 will remain
on the display.
We recommend starting a regeneration cycle as soon as
possible.
steps:Press
Werbung
