Cybex Platinum ANORIS T2 i-Size Benutzerhandbuch Seite 40

2. Close the Linear Side-impact Protection (L.S.P) (1) and keep it
pressed down. Push the L.S.P locking button (22) outwards.
3. As soon as the L.S.P locking button (22) is pushed out to its
furthest extent, the Linear Side-impact Protection (L.S.P) (1) can
be released.
To fold out the Linear Side-impact Protection (L.S.P.) (1) again, press
firmly on the area on the L.S.P. marked with "PRESS".
REMOVING AND REATTACHING THE SEAT COVER
WARNING The car seat must never be used without the seat
2
cover. Ensure that only an original CYBEX seat cover is used, as
the cover is a key element of the seat's function.
To guarantee that your car seat provides the maximum protection, it
is essential to comply with the following points:
The cover consists of 3 components which are attached to the car
seat at several points. Loosen all fixings. Then the individual parts
can be removed. Make sure you only remove the top cover of the
impact shield.
To reattach the cover, proceed in reverse order.
CLEANING
It is important to use an original seat cover only since the cover is an
essential part of the function. You may obtain spare covers at your
retailer.
WARNING The cover is an integral component of the car seat's
2
safety design. The car seat must therefore never be used
without the cover or with a cover of a different car seat.
EN
40