Crivit CMAFP 10.3 A1 Bedienungs- Und Sicherheitshinweise Seite 13

PLEASE NOTE: When disconnecting the valve connection of the compressed air hose
escape from the valve of the inflatable item. Ensure that you remove the valve connection of the
compressed air hose
11
Switching the device on or off
Keep the On/Off switch
„
PLEASE NOTE: If you only press the On/Off switch
Preset mode
Switch the rechargeable bicycle pump
„
Screw the threaded connection of the compressed air hose
„
connection of the rechargeable bicycle pump
8
air hose to the inflatable item which you want to inflate. To do so, please proceed as described in
11
the previous section.
Select the appropriate mode by pressing the "Mode" button
„
mode" ( ), "Motorbike mode" (
You can select the required unit of pressure by pressing the "Mode" button
„
then pressing the "Mode" button
square inch ("PSI"), Bar ("Bar") Kilopascal (kPa) or kilogrammes per square centimetre ("kg/cm²")
(see Fig. A).
Use the "+" button
„
you can keep the respective button pressed down for longer. Pressure settings between 0.2 bar and
10.3 bar are possible in 0.05 bar steps (see Fig. A).
PLEASE NOTE: If a button is not pressed for 5 seconds, the display will display the ACTUAL value
of the pressure. The pressure which has been set remains stored.
Switch the integrated compressor unit on by pressing the On/Off switch for the compressor
„
The compressor will start and pump up the inflatable item.
„
You can switch off the compressor at any time by pressing the On/Off switch for the compressor
„
again.
Once the inflatable item has reached the preset pressure, the compressor will switch off automati-
„
cally.
Disconnect the inflatable item from the valve connection of the compressed air hose
„
in the previous section.
Then unscrew the threaded connection of the compressed air hose
„
hose connection
8
ATTENTION: During operation, the compressed air hose connection
bicycle pump will get hot. Make sure that you do not come into contact with the device during
1
operation. There is a risk of burn injuries. Then wait for at least 10 minutes before you disconnect the
compressed air hose
11a
PLEASE NOTE: After switch-on, the display
made.
PLEASE NOTE: The pressure gauge of the rechargeable bicycle pump
pumping up inflatable items where the wrong pressure could be dangerous (e.g. bicycle tyres), always
check the pressure at a service point with a trade-approved device. Check the pressure of the inflatable
item there.
Tips for use
The device is not intended for continuous operation. The device was designed to create air pressure –
not an air flow. After a long period of continuous operation the device will switch off automatically.
as quickly as possible.
pressed for approx. 3 seconds.
7
on using the On/Off switch
1
), "Bicycle mode" (
again. There is a choice between the following units: pounds per
3
and the "-" button
4 5
of the rechargeable bicycle pump
from the device.
2
briefly, the compressor will start up.
7
onto the compressed air hose
12
. Connect the valve connection of the compressed
1
. You can choose between "Car
3
) or "Leisure equipment mode" ( ).
to select the required pressure. To speed up the selection,
and put it back in the holder provided
1
will deactivate after approx. 3 minutes if no input is
11
.
7
(approx. 3 sec) and
3
as described
11
back off the compressed air
12
of the rechargeable
8
is not trade-approved. After
1
GB/IE/NI/CY/MT
, air can
once.
7
7
.
18
13