Atlas Copco RAB 12 L150 Produktanweisungen Seite 4

Safety and operating instructions
Keep proper footing and balance at all times – stand alert for unexpected tool reaction or breakage of in-
serted tool.
Use a support handle to take up static reaction force and sudden reaction when breaking through, particu-
larly when drilling holes larger than 6.5 mm in metal.
For heavy screw feed drills support handle or reaction bar must always rest against a fixed point. Spindle
torque is high and may break an arm or leg when drawn in or trapped.
When drilling in unknown areas and walls proceed with extreme care. Be alert for hidden gas, water and
electric lines.
If the energy supply is broken – immediately release throttle.
When not using the machine lay it aside in such a way that the risk of unintentional start or other people
getting injured by the inserted tool is minimised.
Long term risks when using the machine
To prevent gradual loss of hearing due to exposure to high noise levels – wear ear protection if the
tool itself or the process generates a high noise.
Vibration may be harmful to hands and arms – reduce total time of exposure to vibration caused by im-
properly working drill bits or other inserted tools.
Avoid inhaling dust resulting from drilling operation.
The dust may be harmful to health.
Use a dust extraction system or an approved dust mask when necessary.
Maintenance
Good service life and safe function is offered if the instructions for lubrication, maintenance and overhaul
supplied with the machine are followed.
Use genuine Atlas Copco replacement kits and parts only.
Warning
Make sure you are familiar with the operating instructions before you use this machine.
This machine, its attachments and accessories is intended to be used for drilling, reaming, countersinking
or tapping.
If using other accessories carefully follow the instructions concerning speed limits, support handle (for tak-
ing up sudden reaction forces) as well as personal protection needed for the application.
For product liability and safety reasons any modification to the machine, its attachments or accessories
must be agreed in advance with an authorized technical representative of the manufacturer.
To prevent personal injury:
■
Familiarize yourself with the enclosed leaflet "General Safety Instructions for Drilling and Tapping".
■
Mind your hands – always use the proper support handle supplied to take up the reaction torque.
Warning
Disassembly and assembly precautions
The rotor blades (vanes) in the tool contains PTFE. The normal health and safety recommendations con-
cerning PTFE must be observed when handling these rotor blades. Particles from wear of blades might be
found in the machine housing or on the blades. Make sure that these particles do not get in contact with
open fire. Wash your hands before smoking since PTFE-particles heated by glow can produce fumes
which may cause an allergic reaction.
4
EN
© Atlas Copco Industrial Technique AB - 9836 9734 01
RAB 12 L