Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Troubleshooting Guide
If you experience a problem, please check the following table before requesting repair. If the problem is not resolved
after the suggested procedure is followed, or if the problem is not described in the table, please consult your dealer
regarding repairs to the unit.
The power does not turn
| The AC power cord is not correctly
Connect the AC power cord securely.
on.
connected.
The power is on, but no
The PHONO/LINE switch is set to
Check the source and set the switch
sound is produced.
another source.
to the correct position.
he external equipment is not connected
! Make sure all connections to other
properly.
equipment are correct.
The volume level adjustment knobs and
| Set the volume level adjustment
the fader are set to MIN or O.
knobs and the fader to appropriate
levels.
The right and left sounds | The right and left connections to the
Correct the connections.
are reversed.
connected equipment are reversed.
During operation,
a hum
An electrical appliance such as a
Increase the distance between the
or buzzing sound
is
fluorescent light or its power cord is too
power cord of the fluorescent light or
heard.
near the connection cord.
other appliance and this unit.
The ground wire of the record player is
Connect the ground wire properly.
not connected.
The fader (sliding volume | The fader is used up.
Replace with a new fader.
control) does not seem to
* Consult your dealer.
work.
The cross fader and CUT
| The OFF/ON switch for the CROSS
Set the switch to ON.
buttons do not work
FADER is set to OFF.
Werbung
