Genmitsu CNC Router 3018- PROVer Mach3 Bedienungsanleitung Seite 42

Part 5 - Troubleshooting
Hopefully everything works as expected,
Symptom
Router is totally unresponsive
Mach 3
An Axis does not move
The wrong Axis moves
Limit switch does not work
Spindle motor does not turn
Spindle motor turns but the LED
does not light
Limit switch LED stays on
Homing Cycle fails
Z-Probe fails
After running a Z-Probe the tip of the
bit is not level with the top of the bed
but if not:
The Emergency
to
connected the jumper is in place in the motherboard socket.)
The Stepper motor wiring is correct.
The Stepper motors are connected to the correct motherboard
The cable connections
The cable connections
The Spindle motor cable Red wire is connected to M+ on the spindle motor and the
Black wire to the
The spindle is not too close to the edge of the axis.
Limit switch connections
The bit is conductive
The Z-Probe connection
Adjust the Z-Probe base height in the Z-Probe code accordingly
Check
Stop Button is in the Out position. (Ifthe Emergencystop Buttonis not
for the limit switch.
for the spindle motor.
M-
and cabling
and clean.
to the motherboard is correct
ports.