Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Disclaimer
Before operating your Desktop CNC Machine, please read the manual.
or damage to the CNC Machine.
this
manual
SainSmart
cannot control the conditions
We do not assume responsibility
connected with the assembly,
The information
in this manual is provided without any warranty, expressed
Please be careful
dangerous
areas.
• Genmitsu CNC Machines are for Indoor Use Only
• You must be 18 years or older to operate this machine, unless supervised
• Wear the proper Personal Protection
• Always place the CNC Machine on a stable surface.
• The SainSmart
Genmitsu CNC Machine is supplied with a switching power supply with an input range of 110—230VAC
Never use a different power supply; it may cause malfunctions
• Ensure the Emergency
stop button is easily accessible
• Never disassemble
the Power Supply or Electrical Components
• DO NOT TOUCH the machine spindle, or place any body part near the working area when the machine is operating
Serious Injury may occur.
• DO NOT leave children unsupervised
• DO NOT leave the machine unattended
• Ensure your CNC Machine is in a well-ventilated
Anyone who operates the Desktop CNC machine should know and understand
in which you assemble your Genmitsu CNC machine or verify if it was done properly
and expressly disclaim liability for loss, injuries, damage, or expense arising out of, or in any way
handling, storage, use, or disposal of the product.
when using your CNC machine.
Equipment
(Safety Glasses etc.)
at all times
with the CNC Machine even when it's not operating
while it's operating
area. Some Materials may discharge
Failure to do so may lead to personal injury, poor results,
or implied, regarding
This machine
is an electrical
by a knowledgeable
or damage to the machine
This will VOID the warranty
smoke or fumes during operation
the contents of
its correctness.
device with moving
parts and
adult familiar with the machine
Injury may occur.
03
Werbung
