Busch+Müller IQ-XL Highbeam Montage- Und Bedienungsanleitung Seite 14

The standlight can be turned off with a long push on the handlebar switch
in the capacitor, and a repeated long push on the handlebar switch
appr 30 seconds. This can assist in short term orientation in the dark. The headlight will extinguish as
soon as the charged energy is dissipated.
7.2. SENSO operation
When switched on, the headlight is always in the SENSO mode. (The pre-requisite for a functioning
SENSO mode is a constantly running hub dynamo). Even if the headlight has been switched off while
cycling, it is switched back on in the SENSO mode when you continue your ride after an extended stop.
In bright light, the headlight operates in the daytime running light (DRL) function. The low beam of
the headlamp is dimmed. The additional daytime running LEDs light up at full brightness for maximum
visibility to oncoming traffic! At dusk and in the dark, the headlight automatically switches to the night
mode. The headlight shines brightly onto the road. The additional daytime running LEDs are dimmed
but still clearly visible to ensure maximum visibility on the road.
The headlight's light/dark sensor has a switchover delay of approx. 8 seconds from the night to the
day mode. This provides additional safety. Consequently, the mode does not temporarily switch to
the daytime running light due to the headlights of passing cars, and provides greater safety thanks to
constant illumination of the road
Overvoltage protection: This function is effective even without a rear light connected.
If one LED breaks down, the entire function fails.
26
3 . This will retain the charge
will re-activate the standlight for
3
NOTICE If a function LED breaks down, the respective function fails completely and the head-
light switches to low beam. If a driving light (low beam) LED fails, the headlight can no longer be
switched on again.
7.3. High beam
When the headlights are on (low beam), the high beam function is switched on or off with a short
press of the handlebar switch.
If the daytime running light function is on due to sufficient ambient brightness, the headlight lights up
briefly in a headlight flash when briefly pressing the handlebar switch.
When the high beam function is switched on, the LED in the handlebar switch lights up blue.
!
The high beam function can be switched on at speeds of 8-12 km/h and above. If the speed drops
considerably, the high beam function is automatically deactivated or cannot be switched on.
The operation of the high beam function is governed by the provisions of the road traffic regula-
tions. The high beam function must not be activated in built-up areas or on roads with adequate
road illumination throughout. The high beam function must not be used in cases where other
road users could be dazzled. Remember to dip your headlights well in advance.
The high beam function can be used as a headlight flasher by briefly pressing the handlebar
switch twice. This use is only permitted in situations where another road user should be made
aware that they are endangering themselves or others.
NOTICE Use the high beam only if it does not dazzle anyone else!
27