Busch+Müller IQ-XL Highbeam Montage- Und Bedienungsanleitung Seite 11

4. Legal regulations
Before you operate your vehicle in public traffic, you are obliged to ensure that your vehicle complies
with national and local laws and regulations, and you, as a traffic participant must abide by the traffic
regulations that apply. These can be found in the Highway Code or national equivalent, and depending
on the country, also at other sources.
In Germany, the prescribed mounting height for headlights
consult your national Road Traffic Regulations or contact a local bicycle specialist retailer. Always make
sure the headlight is mounted and aligned in a way to ensure that oncoming traffic is not blinded.
!
Make sure the headlight is not covered under any circumstances. Also, take care that the headlight
has been mounted and aligned as prescribed.
5. Technical specification
Headlight dimensions: width: 71 mm | height: 65 mm | depth: 62 mm | Weight without bracket: 233 g |
Low beam brightness in low-power-mode: 200 Lux, in high-power-mode: 300 Lux | high beam brightness:
250 Lux
Requirement: 6 V AC / 3 W (hub dynamo operation)
20
1 is between 40 and 120 cm. For details,
6. Assembly
6.1. General assembly instructions
Headlights and cabling - in particular the cable connecting handlebar switch to the headlight
- must all be securely fastened to the bicycle so that they do not obstruct the ride or pose a
hazard. Cables or headlights getting caught in the wheel spokes pose a risk of injuries or fatal
accidents. Securely fasten the headlight to the bicycle using the enclosed Busch+Müller bracket
on the fork crown so that it does not move inadvertently, and its position on the bicycle cannot
change. This setting must be checked before first use. If other brackets are used, no guarantee
can be given for secure attachment.
WARNING
To avoid falls, accidents and severe injuries, always use the enclosed Busch+Mül-
2
ler assembly bracket . If unsuitable or improperly positioned brackets are used, the headlight
may loosen and change position, slide down and, in the worst case, get caught in the wheel
spokes.
NOTICE
Never mount brackets on conical components!
Make sure to tighten all screws just sufficiently to ensure the headlight
vertently. This is particularly important when travelling on uneven terrain.
1
cannot move inad-
21