Werbung
Verfügbare Sprachen
Verfügbare Sprachen
15. Troubleshooting / fault codes
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
15.1 Fault table
Fault
Mower does not start
LED light on charging station
does not light up
LED light on charging station
flashes red
Mower does not mow properly Blades are worn
Mower starts at unusual/
wrong times
Mower gets stuck
15.2 Fault codes
Error code
Meaning
----
Rain sensor delay
Mower outside the
E1
working area
E2
Wheel motor blocked
E3
Cutter disc blocked
Obstacle
E4
sensor trigger not
reset
Possible cause
Mower or charging station not con-
nected to the mains
Boundary wire is not connected or
cut/broken.
Date/time is incorrectly set
Unsuitable terrain/obstacle
Remedy
• -
1. Check that the mower is in the working area.
2. Ensure that the charging station is properly connected to the battery charger
and charger is connected to a suitable power supply.
3. Make sure that the boundary wires have been clamped correctly and replace
them if necessary.
1. Switch the mower off. Move the mower to an area that is free of obstacles.
Press the "START" button and then the "OK" button.
2. If the error message is still displayed, switch off the product. Turn the mower
upside down and check what is preventing the wheels from turning.
3. Remove the objects blocking the wheel(s), turn the mower over.
4. Press the "START" button and then the "OK" button.
1. Switch the mower off.
2. Turn the mower upside down and check what is preventing the blades from
turning.
3. Remove the objects and turn the mower over.
4. Place the mower in an area with short grass.
5. Press the "START" button and then the "OK" button.
1. If the error still occurs, contact your specialist dealer.
www.scheppach.com
Remedy
• Connect the power supply unit to a suitable
power source
• Call a specialist if necessary
• Connect/repair boundary wire
• Replace the blade
• Set the correct date and time
• Adapt the terrain/obstacle to the requirements
of the robotic lawnmower
• Adjust the laying of the boundary wire accord-
ingly
GB | 35
Werbung
