PREPARING
Installing
battery
The
Auto
Meter
alkal ine-manganese
valent), 6V lithium (2CR-1 /3N or equivalent), or 6.2V
silver-oxide
(4SR44,
battery
(C).
To install the battery:
1. Remove
the battery-chamber
down
on it, then sliding it in the direction
arrow
(D).
2.
Insert the battery
ends as indicated
3. Replace the cover by realigning
towards the meter until it snaps into place.
After
the
battery
several seconds for the display to initially
stabilize.
The
meter
display:
1.4
2
NOTE
If the battery
will
not operate.
2
THE
METER
IIIF
is powered
by a single
(4LR44,
Eveready
537,
Eveready 544, or equivalent)
cover
by
with the plus (+) and minus
inside
the battery
chamber
it, then sliding
has been
installed,
it will
will
then
show
the
28
4
56
g
11
16
22
32
45
is not
installed
properly,
Power
consumption
Although there is a constant power supply to the
memory,
non-measuring mode is minimal, so a power switch is
6V
not
necessary.
or equi-
matic cancelling feature that clears the display approx-
imately two minutes after a measurement has been
taken or the last key has been released. To activate the
meter when the display is off , pressthe recall key (the
most recent measurement
pressing
or the measuring
of the
ment
will
setting/display mode; a new measurement is taken and
displayed if the meter is in the time-setting/display
mode).
it
When the battery's
insufficient
take
approximately
appear and
button
is pressed. If this happens, replace the battery
following
with
a fresh
exhausted,
the measuring button
NOTE
•
If the
more, it is advisable to remove the battery.
the
meter
the
meter's
power
consumption
Instead,
the meter
will appear in the display),
button
(the
most recent measure-
appear
if the
meter
is in the film-speed
power
drops to a level almost
for operation, the display will blink for
eight
seconds when the measuring
one.
When
the
battery
the display will remain blank after pressing
or recall key.
meter
is not
to be used for
in
the
employs
an auto-
is completely
two
weeks
or