Flash; Flash/Ambient-Light Readings - Minolta Auto Meter Iiif Bedienungsanleitung

NOTE
• In flash-measuring mode,
increase key, decrease
not function.
• When the mode-selector

"FLASH"

to "AMBI"
any data in memory will be erased.
• If the mode-selector switch
to "FLASH" when the film
press the ASA/TIME key.
to:
14 2 2-8 4
FNo.
Then press the measuring button to take a reading.
• If a flash measurement
into account is necessary at 1/125
daylight sync), take and memorize readings at
"60" and ' '250", then press the averaging key.
• Bulb flash cannot be measured.
the ASA/TIME key,
and FNO./EV key do
key,
switch is slid from
"AMBI" to "FLASH",
or
is slide from "AMBI"
speed is on display,
The display will change
11 22 32 45
a
which takes ambient light
sec. (e.g. for
Flash/ambient-light readings
In flash-measuring mode,
pressed once to prepare the
reading, then pressed again, the meter will measure
ambient light. Using this feature,
and flash measurements
comparison, as when determining contrast of flash/
ambient light for fill-in flash pictures.
Proceed as follows:
Set film speed and slide the mode-selector
I.
to "60" or "250".
Press the measuring button,
2.
ing button again. The ambient-light
appear on the display.
Press the memory key to memorize
3.
Press the measuring button once more, then fire
4.
the flash unit.
The flash reading will
and the analog display will show both the ambient-
light and flash readings.
If the second measurement
flash or ambient-light reading can be taken and seen in
the analog display, along with the first two readings.
if the measuring button
meter to take a flash
both ambient-light
can be memorized for easy
switch
then press the measur-
reading will
this reading.
then be displayed digitally,
is memorized, another
is
11