cancelled.
The oven is operative in this mode.
Function selector must be set OFF if
the oven isn't going to be used.
In this mode all leds are off.
Cancelling the Buzzer Sound
When the set cooking time or alarm
time is finished the buzzer sound will
be heard.
Push the knob to cancel the buzzer
sound. If the knob is not pushed within
1 minute the buzzer sound will be
cancelled automatically.
Cancelling the Alarm or Cooking
Time
Push the knob for about 3 seconds
to cancel the adjusted alarm. Minute
hand and second hand will show the
current time.
4.4 Accessories
The EasyFix Wire Rack
Clean the accessories thoroughly with
warm water, detergent and a soft
clean cloth on first use.
5
4
3
2
1
• Insert the accessory to the correct
position inside the oven.
• Allow at least a 1 cm space between
the fan cover and accessories.
• Take care removing cookware and/
or accessories out of the oven. Hot
meals or accessories can cause
burns.
• The accessories may deform with
heat. Once they have cooled down,
they will recover their original
appearance and performance.
• Trays and wire grids can be
positioned on any level from 1 to 5.
• Telescopic rails can be positioned
on levels T1, T2, 3, 4, 5.
• Level 3 is recommended for single
level cooking.
• Level T2 is recommended for single
level cooking with the telescopic
rails.
• The turnspit wire grid must be
positioned on Level 3.
• Level T2 is used for the turnspit
wire grid positioning with telescopic
rails.
****Accessories may vary depending
on the model purchased.
The Deep Tray
The deep tray is best used for cooking
stews.
Put the tray into any rack and push
it to the end to make sure it is placed
correctly.
The Oil Filter
The oil filter is used when a function is
T2
selected that requires operation of the
T1
fan, for example the Turbo function.
The filter will protect the fan impeller
(located behind the fan cover) from
spattered fat or oil.
Installation / Removal of the Oil
Filter
To install the oil filter, use the holder to
push the oil filter onto the fan cover.
Make sure that the notches on the oil
filter are inserted into the slots on the
fan cover.
EN - 18