Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Avoid location near a heat source, eg, cooker, boiler or radiator. Also, avoid direct sunlight in out-
buildings or terraces/outside seating areas. If you are placing your appliance in an out-building such as
a garage or annex ensure that it is placed above the damp course, otherwise condensation will occur
on the cabinet. Never place the appliance in a wall recessed or into fitted cabinets or furniture
when it is working, the metal grid at the back may become hot and the sides warm.
Recommendation combination:
The following combination of drawers, baskets, and shelves is recommended for energy to be used as
efficiently as possible by the refrigeration unit.
Leveling the appliance
If your appliance is not leveled, the door and magnetic seal alignment will be affected
and may cause a malfunction. Once the appliance is placed in its final location, adjust
the leveling feet at the front by turning them.
Cleaning before use
Wipe the inside of the appliance with a weak solution of bicarbonate of soda. Then rinse with warm
water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy water and dry
completely before replacing them.
Before plugging in
Check that you have a socket which is compatible with the plug supplied with the appliance.
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE APPLIANCE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes before
switching back on to allow the coolant fluid to settle.
Before filling your appliance
Before storing foods in your appliance, turn it on and wait for 24 hours, to make sure it is working properly
and to allow it to reach the correct temperature.
4. USE INSTRUCTIONS
Temperature setting:
Your refrigerator has one control for regulating the temperature. The temperature control is located at
the top of the fridge.
The first time you put your appliance into operation, set the thermostat to "MED" (4 to 5) and let it run
empty for 4 hours before storing food for it to cool sufficiently.
The range of the temperature control is from position "1" the warmest to "8" the coldest. Adjust the
temperature control to the setting that best suits your needs. The setting of "MED" should be appropriate
25
Werbung
