Hilti DX 36 Bedienungsanleitung Seite 33

Fault
Misfire: the fastener is only
partly driven into the base ma-
terial.
en
The cartridge strip doesn't ad-
vance.
The cartridge strip cannot be
removed.
A cartridge doesn't fire.
28
Possible cause
The piston was in the wrong position.
Bad cartridges.
The cartridge strip is damaged.
The tool needs to be cleaned.
The tool is damaged.
The tool has overheated.
Bad cartridge.
The tool needs to be cleaned.
Remedy
Remove the cartridge strip and cycle
the tool.
See section: 8.5 Cycling the tool 6
Change the cartridge strip (use a dif-
ferent / dry package if necessary).
If the problem persists: service the
tool (see 9.3)
Change the cartridge strip.
Clean the tool.
If the problem persists, contact your
local Hilti Center.
Allow the tool to cool down.
Subsequently, carefully remove the
cartridge strip from the tool.
WARNING
Do not attempt to forcibly remove
cartridges from the magazine strip or
tool.
If the problem persists, contact your
local Hilti Center.
Pull the cartridge strip through to the
next cartridge.
Servicing the tool
WARNING
Check that the correct cartridges are
used and that they are in faultless
condition.
See section: 9.3 Servicing the tool
If the tool cannot be disassembled,
contact your local Hilti Center.