Start-Up And Use; Using The Hob; Using The Oven - Indesit KN6T62 SA Bedienungsanleitung

Start-up and use

Using the hob

Lighting the burners
For each BURNER knob there is a full ring showing
the strength of the flame for the relevant burner.
To light one of the burners on the hob:
1. Bring a flame or gas lighter close to the burner.
2. Press the BURNER knob and turn it in an
anticlockwise direction so that it is pointing to the
maximum flame setting E.
3. Adjust the intensity of the flame to the desired
level by turning the BURNER knob in an
anticlockwise direction. This may be the minimum
setting C, the maximum setting E or any position in
between the two.
The appliance is fitted with
an electronic lighting
X
device*(D) ( see figure ),
Press the BURNER knob and
turn it in an anticlockwise
direction, towards the
D minimum flame setting, until
the burner is lit. The burner may be extinguished
when the knob is released. If this occurs, repeat the
operation, holding the knob down for a longer period
of time.
! If the flame is accidentally extinguished, switch off
the burner and wait for at least 1 minute before
attempting to relight it.
The appliance is equipped with a flame failure safety
device (X); press and hold the BURNER knob for
approximately 3-7 seconds to keep the flame alight
and to activate the device.
To switch the burner off, turn the knob until it
reaches the stop position •.
Burner ø Cookware Diameter (cm)
Fast (R)
Semi Fast (S)
Auiliary (A)
Triple Crown (TC)
Practical advice on using the burners
For the burners to work in the most efficient way
possible and to save on the amount of gas
consumed, it is recommended that only pans that
have a lid and a flat base are used. They should
also be suited to the size of the burner:
To identify the type of burner, please refer to the
diagrams contained in the "Burner and nozzle
specifications".

Using the oven

! The first time you use your appliance, heat the
empty oven with its door closed at its maximum
temperature for at least half an hour. Ensure that the
room is well ventilated before switching the oven off
and opening the oven door. The appliance may emit
a slightly unpleasant odour caused by protective
substances used during the manufacturing process
burning away.
! Before operating the product, remove all plastic
film from the sides of the appliance.
! Never put objects directly on the bottom of the
oven; this will avoid the enamel coating being
damaged.
1. Select the desired cooking mode by turning the
SELECTOR knob.
2. Select the recommended temperature for the
cooking mode or the desired temperature by turning
the THERMOSTAT knob.
3.A list detailing cooking modes and suggested
cooking temperatures can be found in the relevant
table ( see Oven cooking advice table ).
24 - 26
4. During cooking it is always possible to:
16 - 20
• Change the cooking mode by turning the
10 - 14
• Change the temperature by turning the
24 - 26
• Stop cooking by turning the SELECTOR knob to
! Always place cookware on the rack(s) provided.
WARNING! The glass lid can break in
if it is heated up. Turn off all the burn-
ers and the electric plates before
closing the lid. *Applies to the models
with glass cover only.
SELECTOR knob.
THERMOSTAT knob.
the "0" position.
GB
7