Elegoo Centauri Benutzerhandbuch Seite 10

Machine Setup & Installation
4
4. Install the screen into the corresponding slot on the printer
and push it down to lock it in place.
6
6. Install the spool holder by aligning it with the hole on the back
panel, and tighten it by turning counterclockwise.
Important note: If you have disassembled machine components such as the nozzle assembly or build platform, make
sure to re-level the platform before printing.
5
5. Secure the filament detector to the back panel of the machine
using the screws provided in the accessory kit.
7
7. Load the filament by inserting one end into the filament detector
and pushing it forward until it reaches its maximum position.
8