Neonate BC-6900D Bedienungsanleitung Seite 8

8 ENGLISH
Pairing (connecting) units
NOTE: PU and BU are already paired and ready to use out
of the box. Nevertheless, we recommend you to pair the
units again to ensure a private connection. If you want to
connect another baby unit (or extra baby unit) to the parent
unit you need pair units again.
Parent unit: Press and hold the "BU#" button and set
1
the ON/OFF switch to ON position. Do not release the
"BU#" button before PAIR is showing in display.
Baby unit: Press and hold the "TIMER" button and set
2
the ON/OFF switch to ON position. Do not release the
"BU#" button before PAIR is showing in display.
Baby unit: Use the "+/-" buttons to select the baby
3
unit's number 1, 2 or 3). Press the "M" button to
confirm your choice. The number you have selected
will stop flashing.
Baby unit: Press "M" again to confirm the pairing
4
between PU and BU. Two beep sounds will confirm
that the units are paired.
Repeat step 2, 3 and 4 if you wish to pair more baby
units to the same parent unit.
Both units: Turn the units off and on by setting the ON/
5
OFF switch to OFF, and then back to ON again. The
units are now ready to use.
NOTE: If you wish to pair more than one baby unit to the
parent unit, you will have pair all the baby units before you
proceed with step 5. It is not possible to add/connect more
baby units later without pairing them all again.
"BU#" button
ON/OFF switch
Parent unit
"TIMER" button
ON/OFF switch
Baby unit
Turn on and adjusting the temperature alarm
The parent unit must be turned on.
Parent unit: Press and hold the "M" button for 2 sec-
1
onds. SLEEP TIMER will appear steady and ON or OFF
will be flashing in display.
Parent unit: Press the "M" button three times. The
2
display changes from SLEEP TIMER to TEMP ALARM
HIGH.
Parent unit: Use the "+/-" buttons to select the upper
3
tempera ture limit. If current temperature exceeds chosen
temperature, the temperature alarm will go off.
Parent unit: Press the "M" button once. The display
4
changes from TEMP ALARM HIGH to TEMP ALARM
LOW.
Parent unit: Use the "+/-" buttons to select the lower
5
tempera ture limit. If current temperature goes below
chosen temperature, the temperature alarm will go off.
Parent unit: Press the "M" button once more. The parent
6
unit will return to standby mode. The upper and lower
temperature limits are now adjusted/defined.
NOTE: Both the upper and lower temperature limit can be
turned off completely The upper temperature limit can be
turned off by pressing the "+" button until the temperature
limit is set at +50°C, and then pressing the "+" button once
more. The lower temperature limit can be turned off by
pressing the "-" button until the temperature limit is set at
-19°C, and then pressing the "-" button once more (OFF
will show in display instead of selected temperature limit).