Midea 7NP30T0BL Gebrauchsanleitung Seite 98

the door, and you may be trapped. Keep your hands away from the
hinges.
▲
Change the power cord
Position A show the terminal box position on the back of the back
outer case and it's closed.
Steps:
1. Cut off the power, use small flat screwdriver to open two snap 1, 2.
2. Use Phillips screwdriver to take off screws 3, 4, 5 and 6.
3. Change the new power cord ,fix the yellow/green wire on 3,
brother wire on 4, blue wire on 5.
4. Twist screw 6 closed the terminal box cover finish the changing.
A
back outer case
▲
CURE YOUR APPLIANCE WHEN NEEDED
If a fault occurs, before calling the after-sales service, please ensure
that is not because of incorrect operations and refer to the fault table,
attempt to correct the fault yourself. You can often easily rectify
technical faults on the appliance yourself.
If a dish does not turn out exactly as you wanted, you can find many
tips and instructions for preparation at the end of the operating
manual.
Fault
The
appliance
does not
work.
Knobs
have fallen
out of the
support in
the control
panel.
power cord
Possible Cause
Faulty fuse.
Power cut
Knobs have been
accidentally
disengaged.
brown {L}
yellow/green
blue {N}
Check the circuit breaker in the fuse
box.
Check whether the kitchen light or
other kitchen appliances are working.
Knobs can be removed.
Simply place knobs back in their
support in the control panel and push
them in so that they engage and can
be turned as usual.
EN-40
3
1 2
6
terminal box
Notes/remedy
4
5