Ego Power+ HTA2000S Bedienungsanleitung Seite 12

1. Depending on which screw you are removing, hold
EN
the hedge trimmer on its side or lay it on its back
so that the sealing screw to be removed is facing
upwards (Fig. O & P).
2. Use the wrench provided to loosen and remove the
sealing screw.
3. Use a grease syringe (not included) to inject some
grease into the screw hole; do not exceed 3/4 capacity.
4. Tighten the sealing screw after injection.
STORING THE UNIT
◾
Remove the battery pack from the tool.
◾
Clean the tool thoroughly before storing it.
◾
Put on the blade scabbard onto the cutting blade
before storing or transporting. Use caution to avoid the
sharp teeth of the blades.
◾
If the hedge trimmer is removed from the power
head and stored separately, fit the end cap on the
attachment shaft to avoid dirt getting into the coupler.
◾
Store the unit in a dry, well-ventilated area, locked-up
or up high, out of the reach of children. Do not store
the unit on or adjacent to fertilizers, gasoline, or other
chemicals.
12
HEDGE TRIMMER ATTACHMENT — HTA2000S
Protecting the environment
Do not dispose of electrical equipment,
used battery and charger into household
waste! Take this product to an authorized
recycler and make it available for separate
collection. Electric machines must be
returned to an environmentally compatible
recycling facility.