Before Use - Panasonic EH2424 Bedienungsanleitung

Parts identification
D
q Nozzle
A
w Steam outlet
Nano-sized ion steam is discharged.
e Power switch
r Test switch
The test switch is used to check the
ionization (atomization) of the steam.
The ionize lamp turns off and non-ionized
steam is discharged only while the test
switch is pressed.
t Ionize lamp
The lamp turns on when the power is
turned on. The lamp turns off while the
test switch is pressed.
y Cord
u Main panel
i Cosmetic ring
D
o Water inlet gasket
B
!0 Water inlet
D
!1 Water supply cover
C
!2 Water supply cover open button
!3 Handle
!4 Water level
When water is filled to the "full" mark, the
appliance can be used for approximately
12 minutes.
!5 Drain cup
Water collects in the drain cup if too much
water is added.
D
!6 Water supply cup
D
When water is filled to the "full" mark (top
level inside the cup), the appliance can
be used for approximately 12 minutes.

Before use

1. Excessive use is detrimental to the skin.
• It is recommended that you start by using
the appliance two to three times a week.
Thereafter, adjust the frequency and
duration of use while observing the condition
of your skin.
If any skin trouble develops, stop use
immediately.
• Recommended usage is once a day.
2. Your skin condition also may differ according
to your health.
• Use the appliance while observing the
condition of your skin.
3. If you feel any skin discomfort, such as rash,
(Fig. 1)
redness, itching, and so forth, stop use and
consult a physician.
4. Skin problems may be caused by stress,
health, organic disorder or cosmetics.
In such instances, consult a specialist.
Preparation
1. Check that the drain cup is installed in the
appliance.
2. Press the water supply cover open button to
lift up the water supply cover. (Fig. 2)
3. Use the water supply cup to fill the appliance
with water.
• Use distilled water or water that has been
softened by a water softener.
The water softener is separately available.
(Fig. 3)
When using the separately available water
softener, read the supplied operating
instructions before use.
If hard water is used, the mineral content of
the water will form deposits on the inside of
the boiler of the appliance and may obstruct
the flow of steam.
• Be careful not to let water come in contact
with the nozzle, cosmetic ring, main panel,
and switch.
• Dispose any leftover water in the water
supply cup.
• Do not add water past the full mark on the
water supply cup or if water remains in the
appliance. (Check the water level and add
water only when there is no remaining water
in the appliance.)
4. Close the water supply cover.
Using the facial ionic steamer
1. Insert the plug into a power outlet and press
the power switch until a click is heard.
• Ionize lamp turns on.
• Ionized steam is released after about 30
seconds.
- It is normal for hot water droplets to be dis-
charged at the begining of the steam flow.
- A whizzing may be heard. This is the sound
of electric discharge which is normal.
• Do not operate the appliance with the water
supply cup placed on the nozzle.
2. Adjust the angle (up/down) of the nozzle. (Fig. 4)
6