Cleaning the Sensors, Camera
Window and Charging Contacts
1
Wipe Sensors, Camera Window
and Pad Shelf with a clean, dry
cloth.
Note:
Inspect the Camera Window. If
you notice any cracks, please contact
Customer Care.
Important:
Do not spray cleaning
solution or water onto the Sensors or
Sensor openings.
Replacing the Bag
1
Lift the Canister Lid up to open.
2
Pull the plastic card up to remove the
Bag from the Canister.
Note:
This will seal the
Bag so that dust and
debris cannot escape.
3
Discard the used Bag.
4
Install a new Bag, sliding the
plastic card into the Guide Rails.
5
Press down on the Lid making sure
that it is completely closed.
Note:
To achieve optimal performance
with your robot and Automatic Dirt
Disposal, clean and/or replace your
robot's Filter as needed.
Roomba Combo™ j7+ Owner's guide
EN
10