iRobot Roomba Combo j7+ Bedienungsanleitung Seite 15

Cleaning the front Caster
Wheel
1
Pull firmly on the front Wheel
EN
module to remove it from the robot.
2
Pull firmly on the Wheel to remove
it from its housing (see illustration
below).
3
Remove any debris from inside
the Wheel cavity.
4
Reinstall all the parts when
finished. Make sure that the Wheel
clicks back into place.
Axle
Housing
Important: A front wheel clogged with
hair and debris could result in damage
to your floor. If the Wheel is not spinning
freely after you have cleaned it, please
contact Customer Care.
9 For more information, visit global.irobot.com
Washing the Bin
Important: Do not wash the Filter.
Remove the Filter before washing
the Bin.
1
Release the Bin, remove the Filter and
open the Bin Door.
2
Rinse the Dust Bin and Water
Tank using warm water.
Wheel
Note: The Bin is not dishwasher
safe.
3
Make sure that the Bin is
completely dry. Reinsert the
Filter and place the Bin back
into the robot.
Cleaning the Edge-Sweeping Brush
1
Use a coin or small screwdriver to remove
the screw holding the Edge-Sweeping
Brush in place.
Pull to remove the Edge-Sweeping Brush.
2
Remove any hair or debris, then reinstall
the Brush.