Parkside PLHLA 20-Li A1 Originalbetriebsanleitung Seite 20

GB
Removing the battery
1. Press and hold the battery release (6)
on the battery (5).
2. Pull the battery out of the battery
holder.
Switching on and off
1. Switch on: Press the On/Off switch
(7).
2. Switch off: Press the On/Off
switch (7) again.
Used batteries
• If the operating time is considerably
shortened despite charging, this
shows that the battery is depleted
and must be replaced. Only use an
original replacement battery from
the series X 20 V TEAM, which you
can purchase from the online shop
(see the Spare parts and accessor-
ies, p. 24).
• Always observe the safety informa-
tion in addition to the regulations and
information about environmental pro-
tection (see Disposal/environmental
protection, p. 20).
Cleaning, maintenance
and storage
Switch the device off before cleaning
and remove the battery from the device.
Cleaning
• Clean the device with a soft, dry cloth
to avoid scratching the cover of the
LED lamp.
• Use a brush to clean the gaps on the
device.
20
• Do not use any abrasive cleaning
agents or solvents. You can damage
the device irreparably.
• Do not use water or metallic aids.
Risk of short circuit.
Maintenance
The device is maintenance free.
Storage
Always store the device and accessories:
• clean
• dry
• protected against dust
• protected against frost
• out of the reach of children
The storage temperature for the re-
chargeable battery and the device is
between 0 °C and 45 °C. Avoid ex-
treme cold or heat during storage to en-
sure the battery output is not adversely
affected.
Remove the rechargeable battery from
the device before storing the device (see
the separate operating instructions for the
battery and charger).
Disposal/environmental
protection
Remove the battery from the device and
recycle the device, battery, accessories
and packaging in an environmentally-
friendly manner.
Waste electrical and electron-
ic equipment (WEEE) must not
be disposed of with domestic
waste.