SETTING THE ALARM TIME
1 In Normal Time mode, press "MODE" key twice to enter Alarm Time Mode
2. Press and hold "SET" key for 3 seconds until the HOURdigit flashing
3 press"ADJUST"keyto increasethe alarmhourvalue
4. Repeat the above operation to set the alarm minute.
5. Press "MODE" key or without any operation in 30 seconds to save and exit
the setting mode to normal time mode
NOTE:
The alarm will be automatically activated with the Icon
setting the alarm time
USING THE ALARM AND SNOOZE FUNCTION
1. Set the alarm time as described in the previous section
2 When the alarm is set, twill activate atthe set time The alarm will go off
for 1minutes in crescendo pattern if not interrupted Activate the snooze by
pressing the ADJUST key in alarm time mode so that the snooze icon "Zz"
appears
3. To de-activate the alarm and snooze function, press the ADJUST key until
both icons dlsappear under Alarm time mode
NOTE:
1 When the snooze function is activated, the alarm will automatically Start
again after 4 minutes, total 4 times. It won't sound again afterwards until the
next day
2 When the alarm is sound, press any function keyto stop it
CHECK THE TEMPERATURE AND HUMIDITY
You can check temperature and humidity in the thermometer window and
hygrometer window, the accuracy as fol owing:
Operating Temperature:
Temperature Accuracy:
16
"4" displaying
ooc -wc
±30c
Operating Humidity:
Humidity Accuracy:
BATTERY REPLACEMENT
When the LCDbecomes dim, replace with one new AAA size battery at once
pay attention to the battery polarity
NOTE:
Attention! Please dispose of used unit and batteries in an ecologically
after
safe manner.
IMPORTANT
For best reception, please read the fol owing instructions:
This sophisticated instrument will automatically receive the time signal
transmitted from German, U.K.,U.S.A or Japan Atomic Clock transmitter
(This depend on which version you purchase)
It is strongly recommended to start this clock at night and allow the clock to
receive the Slgnal automatically overnight
Always place the unit away from interfering sources such as TV set,
computer, etc.
Avoid placing the unit on Ornext to metal surfaces
Closed area such as airport, basement, tower block,or factory is not
recommended
DOnot Start reception in a moving article such as vehicle or train
NOTE:
Under the environment with electrostatic discharge, the unit may ma function
and require user to reset it.
30%RH - 90%RH
@25øc
17